USB PCBA Replacement Guide for Pro Grow Boxes

STEPS:

• Remove the screw in your growbox shown in the picture.

• Remove the two screws shown on the back cover.

• Pry open the three clips shown in the image, then remove the cover.

• Hold the two white raised parts shown in the picture and pull outward to remove the two wire bundles.

• Remove the two screws shown, take out the old PCBA, and replace it with the new one.
  Then, reassemble everything by reversing the steps above.
  

Note: When installing the new PCBA, if the two wires shown are hard to plug in, you can gently pull them out a bit to make it easier.

• After connecting, open the bottom cover of the device and pull the wires as shown to tighten the wire bundle.